FOMON01GBBT(1).PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

FORD

MOD. MONDEO*

YEAR. 01 ﬁ

PETROL

DIESEL

MAKE

* Models with original equipment keyless entry system.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens on the support of the shock absorber, in the engine

compartment, driver’s side. To pass the cables use the original rubber sleeve located on the bulkhead

that divides the engine compartment and the passenger’s compartment, near the servobrake.

CENTRAL UNIT POSITION

The modular systems and the modules should be positioned under the dashboard, driver’s side.

POWER SUPPLY

+ 30: Connect to the 4 mm 2 RED wire located in a multiway connector in the fuse box.

- 31: Connect directly to the car body.

IGNITION WIRE

+ 15/54: Connect to the 2,5 mm 2 GREEN/RED wire located in a multiway connector placed in the

front part of the fuse box.

DIRECTION INDICATORS

Connect to the LIGHT BLUE and LIGHT BLUE/RED wires located in the nr. 3 light blue connector , in

the fuse box.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the 2 mm 2 WHITE wire directly on the coming out of the window motor located inside the driver’s

side door.

Front window, passenger’s side:

cut the 2 mm 2 WHITE wire.

Rear window, driver’s side:

cut the 2 mm 2 WHITE/BLUE wire.

Rear window, passenger’s side:

cut the 2 mm 2 WHITE wire.

All these connections are made directly in the wiring harness under the sill cover, driver’s side,

except for that of the driver’s side window.

ACTIVAT./DEACTIVATION

CONTROLS

Connections antithefts/vehicle

38XX vehicle Position

GREY/BLACK ground car body

YELLOW/BLACK YELLOW pos. 4 GREY connector

VIOLET/WHITE ground car body

ORANGE +30 positive in the fuse box

VIOLET BLACK/GREEN pos.16 GREEN connector

ORANGE/WHITE +30 positive in the fuse box

The grey and green connectors are located on the coming out of the central doors locking unit placed

behind the glove compartment, passenger’s side.

Note: The antitheft system will activate making the double central locking.

IMMOBILISATION POINT

Fuel pump

Cut the VIOLET/ORANGE wire located in the wiring harness coming out of the connector of the

inertial switch.

STARTER

+ 50: Cut the wire located in the position marked “+50”, in the wiring harness coming out of the

connector of the ignition key.

BONNET SWITCH

Install an additional switch on the front headlamp support plate, driver’s side.

DOORS SWITCH

Connect to the BLACK/LIGHT BLUE wire located in the nr. 1 grey connector, in the fuse box.

Note: Wait the switch off of the lamp for programming of activation and deactivation controls

BOOT SWITCH

Connect to the BLACK/ORANGE wire located in the wiring harness coming out directly from the boot

lamp.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

fomon01gbbt.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: