SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONSALFA ROMEO 156.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

MAKE ALFA ROMEO MOD. 156* YEAR. 02 2 nd sem. ﬁ

PETROL

DIESEL

* Models with original equipment keyless entry system.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens behind the left lateral headlamp.

CENTRAL UNIT POSITION

The modular systems and the modules should be positioned under the dashboard, driver’s side.

POWER SUPPLY

+30: connect to the general supply wiring at the entrance of the fuse box.

-31: connect directly to the car body.

IGNITION WIRE

+15/54: connect to the RED/ORANGE wire located in the 20 way white connector in the front part of

the fuse box. Alternatively, in the wiring harness located under the sill cover, driver’s side.

DIRECTION INDICATORS

Connect to the 1 mm 2 LIGHT BLUE wire in the 20 way white connector and LIGHT BLUE/BLACK in

the 12 way connector. These connectors are located in the front part of the fuse box, under the

dashboard, drivers side. Alternatively in the wiring harness under the sill cover, driver’s side.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the BROWN/WHITE wire in the wiring harness coming out of the connector of the central located

behind the glove compartment, passenger’s side.

Front window, passenger’s side:

cut the VIOLET/WHITE wire in the wiring harness coming out of the connector of the central located

behind the glove compartment, passenger’s side.

Rear window, driver’s side:

cut the YELLOW/RED wire in the wiring harness under the sill cover, driver’s side.

Rear window, passenger’s side :

cut the LIGHT BLUE/GREEN wire in the wiring harness under the sill cover, driver’s side.

ACTIVAT./DEACTIVATION

CONTROLS

Connections antithefts/vehicle

Art. 3800 Vehicle Position

YELLOW/BLACK WHITE/BLACK Pos. nr.1 in the 16 way connector

GREY/BLACK +30 supply in the fuse box

VIOLET +30 supply in the fuse box

ORANGE +30 supply in the fuse box

VIOLET/WHITE +30 supply in the fuse box

ORANGE/WHITE +30 supply in the fuse box

• For ‘Station Wagon’ vehicles the radio receiver central is placed in the boot behind the plastic

bulkhead, on the passenger’s side wheel house.

• For ‘Sedan’ vehicles the radio receiver central is placed under the shelf of the rear window (keep

off the cover inside the boot).

IMMOBILISATION POINT 1

Gasoil pump

Cut the BLACK/VIOLET wire coming out of the wiring harness of the inertial switch located under the

driver’s side seat.

IMMOBILISATION POINT 2

Central supply

Cut the ORANGE wire in a connector coming out of the central engine plant located under the dash

board, passenger’s side.

STARTER

+50 : Cut the 2 mm 2 RED/BLACK wire located in the wiring harness coming out of the connector of the

ignition key.

BONNET SWITCH

Install an additional switch on the front headlamp support plate, driver’s side.

DOORS SWITCH

Connect to the WHITE/BLUE wire located in the red connector under the left side of the dashboard,

near the handle of the bonnet. Alternatively, in the wiring harness under the sill cover, driver’s side.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

al15602gbdt2s.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: