SKOCT01GBD.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

MAKE

SKODA

MOD. OCTAVIA 1.9 YEAR. 01 ﬁ

PETROL

DIESEL

ALARM/SIREN

POSITION

Position the compact alarms and the sirens on the left of the engine

compartment on the support bracket of the filter for the air-conditioning

system. To enter this zone it is necessary to take down the left

wheelhouse.

CENTRAL UNIT POSITION

Position the modular systems and the modules near the ZM central

located behind the steering column.

POWER SUPPLY

+ 30: connect to one of the positive located on the feed bar placed under

the steering column or as alternative, to the RED/WHITE wire located at

the position nr. 22 of the ZM central.

- 31: use the original ground wire located near the installation point of the

alarm/siren, in the engine compartment. For the modular systems and

eventual module it is suggested to connect to the original ground drive

located on the left pillar or as alternative, to the BROWN wire at the

position nr. 23 of the ZM central.

IGNITION WIRE

+ 15/54: connect to the YELLOW/RED wire at the position nr. 3 of the ZM

central or as alternative, connect to the BLACK/WHITE wire at the

position nr. 5 located in the connector coming out of the same central.

DIRECTION INDICATORS

Connect to the BLACK/WHITE and BLACK/GREEN wires in the wiring

harness behind the sill cover driver’s side.

ELECTRIC WINDOWS

Comfort closing

Negative control signal

This vehicle has the comfort system so, the total closure of the electric

windows is obtained timing the same WHITE/BLUE wire used for the

closing of the doors.

CENTRAL DOORS LOCKING Negative control signal

Connect to the WHITE/YELLOW wire directly on the lock switch (or as

alternative to the WHITE/BLUE wire at the position nr. 2 of the ZM

central) (lock) and to the BLACK/BLUE wire at the position nr. 4 (unlock)

located on the coming out of the ZM central.

IMMOBILISATION POINT

Gasoil pump

Cut the BLACK wire at the position nr. 3 located in the wiring harness

coming out of the red connector, under the dashboard on the relay bar.

BONNET SWITCH

Install an additional switch on the front headlamp support plate.

DOORS SWITCH

Connect to the BLUE/BROWN wire at the position nr. 13 (nr. 16) of the

connector coming out of the ZM central.

BOOT SWITCH

Connect to the BROWN/BLACK wire at the position nr. 15 of the

connector coming out of the ZM central.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

skoct01gbd.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: