TOAVE98GBB.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

TOYOTA

MOD. AVENSIS YEAR 98 ﬁ

PETROL

DIESEL

MAKE

ALARM/SIREN

POSITION

Position the compact alarms and the sirens in the engine compartment, on the

shock absorber support, driver’s side. Pass the cables through the original rubber

sleeve located behind the cover of the wheel housing, driver’s side.

POWER SUPPLY

+ 30: connect to the ground terminal in the general power supply connector in the

fuse box.

- 31: connect with a cable terminal directly to the car body.

IGNITION WIRE

+ 15/54: connect to the 1,5 mm 2 BLUE wire with SILVER references located in the

bundle of cables under the sill cover, driver’s side.

DIRECTION INDICATORS

Connect to the GREEN/BLACK wire with SILVER references and to the

GREEN/YELLOW wire with SILVER references located in the bundle of cables

under the sill cover, driver’s side.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the 1,5 mm 2 GREEN wire located in a wiring harness coming out of the

respective switch connector.

Front window, passenger’s side:

cut the 1,5 mm 2 GREEN/WHITE wire (positive polarity) and the RED/BLUE wire

(negative polarity) located in the wiring harness coming out of the 13 way white

connector, behind the left lateral panel, driver’s side.

CENTRAL DOORS LOCKING Negative control signal

Connect to the BLUE/WHITE wire (lock) and to the BLUE/YELLOW wire (unlock).

Find the wires in the coming out of the 16 way orange connector under the fuse

box, on the left, under the dashboard, driver’s side.

IMMOBILISATION POINT 1

Fuel pump

Cut the 1,5 mm 2 LIGHT BLUE/BLACK wire with SILVER references located in the

bundle of cables under the sill cover, driver’s side.

IMMOBILISATION POINT 2

Inertial switch

Cut both the BLACK/ORANGE wires in the wiring harness coming out of the relay

marked “EFI” of the relay group near the battery.

STARTER

+50: Cut the 1 mm 2 RED wire located in the wiring harness coming out of the

ignition key.

BONNET SWITCH

Install an additional switch on the headlamp support plate, near the bonnet

bumper rubber.

DOORS SWITCH

Connect to the RED/WHITE wire with SILVER reference located in the bundle of

cables under the driver’s side sill cover.

BOOT SWITCH

Connect to the doors line.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

toave98gbb.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: