SETOL00GBB.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

SEAT

MOD. TOLEDO YEAR 00 ﬁ

PETROL

DIESEL

MAKE

ALARM/SIREN

POSITION

Position the compact alarms and the sirens in the engine compartment, on the

bulkhead that divides the engine compartment from the passenger’s

compartment. Pass the cables through the original rubber sleeve located under

the brake fluid reservoir.

CENTRAL UNIT POSITION

Position the modular systems and the modules under the driver’s side dashboard

or as alternative behind the driver’s side panel.

POWER SUPPLY

+ 30: connect with a ring terminal to the pin marked “+30” located on the feed rod

in the lower part of the fuse box.

- 31: connect with a ring terminal to the weight shunting located above, on the

left of the fuse box.

IGNITION WIRE

+ 15/54: connect to the 2 mm 2 BLACK wire in the central part of the fuse box

located on the left lateral bulkhead, driver’s side.

DIRECTION INDICATORS

Connect to the 1 mm 2 BLACK/WHITE and BLACK/GREEN wires located in the

wiring harness coming out of the lights switch connector.

ELECTRIC WINDOWS

Comfort closing

Negative control signal

The total closing of the windows is obtained timing the lock control (Violet) of the

car alarm to 24s.

CENTRAL DOORS LOCKING Negative control signal

Connect to the 0,75 mm 2 YELLOW/BLUE wire (lock) and GREN/RED wire

(unlock) located in the wiring harness that goes from the push-button panel to the

switch directly inside the driver’s side door.

IMMOBILISATION POINT 1

Fuel pump

Cut the 1 mm 2 BLUE/YELLOW in the wiring harness coming out of the 6 way

light brown connector located on the connectors holder, under the driver’s side

dashboard.

IMMOBILISATION POINT 2

Positive relè pump

Cut the 1 mm 2 RED/VIOLET wire located on the coming out of the fuse marked

nr. 32, in the fuse box, above the left lateral panel, driver’s side.

BONNET SWITCH

Install an additional switch on the headlamp support plate, above on the left of the

driver’s side lamp.

DOORS SWITCH

Connect to the 1 mm 2 GREY/BLUE wire located at the position nr. 16 of the

connector coming out of the central doors locking unit under the driver’s side

dashboard.

BOOT SWITCH

Connect to the 1 mm 2 BROWN/BLACK wire located in the wiring harness of the

driver’s side sill cover.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

setol00gbb.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: