KICAR02GBDT.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

MAKE

KIA

MOD. CARNIVAL* YEAR. 02 ﬁ

PETROL

DIESEL

* Models with original equipment keyless entry system.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens in the engine compartment, on the support of the

shock absorber, driver’s side.

CENTRAL UNIT POSITION Position the modular systems and the modules on the left, under the dashboard, driver’s side.

POWER SUPPLY

+30: connect to the 4 mm 2 RED wire located in a multiway connector, in the fuse box.

- 31: connect with a ring terminal directly to the car body.

IGNITION WIRE

+15/54: connect to the wire at the position marked “+15/54” directly in the wiring harness

coming out of the connector of the ignition key.

DIRECTION INDICATORS

Connect to the GREEN wire at the position nr. 13 and to the LIGHT BLUE wire at the position

nr. 14 located in the 14 way white connector on the rear of the check control.

ELECTRIC WINDOWS

Front window, driver’s side:

cut the BLUE and WHITE wires located in the wiring harness coming out of the 9 way white

connector on the push-button panel of the driver’s side door.

Front window, passenger’s side:

cut the RED/YELLOW and GREEN wires in the wiring harness coming out of the 12 way white

connector, above the fuse box.

Rear window, driver’s side:

cut the RED and WHITE wires in the 10 way white connector coming out of the push- buttons

near the wing mirror.

Rear window, passenger’s side:

cut the GREEN and YELLOW wires in the 10 way white connector coming out of the push-

buttons near the wing mirror.

ACTIVAT./DEACTIVATION

CONTROLS

Connections antitheft/vehicle

Art.3800 Vehicle Position

YELLOW/BLACK BLUE driver’s side door output

GREY/BLACK RED/BLACK driver’s side door output

VIOLET YELLOW/BLACK driver’s side door output

VIOLET/WHITE ground car body

ORANGE positive fuse box supply

ORANGE/WHITE positive fuse box supply

Refer to ‘B’ diagram in the dedicated installations manual, inside the kit of the antitheft.

IMMOBILISATION POINT

Gasoil pump

If the vehicle has the inertial switch, it is suggested the interruption of one of the two wires

coming out from the same.

STARTER

+50: Cut the wire located at the position marked “+50” directly in the wiring harness coming out

of the ignition key.

BONNET SWITCH

Install an additional switch on the front headlamp support plate.

DOORS SWITCH

Connect to the GREEN wire at the position nr. 1 in the 14 way white connector

located on the rear of the check control.

BOOT SWITCH

Connect to the GREEN/BLACK wire at the position nr. 8 in the 14 way white connector located

on the rear of the check control.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

kicar02gbdt.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: