BMZ403GBBT.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

BMW

Z4*

YEAR 03 ﬁ

PETROL

DIESEL

MAKE

MOD.

* Models with original equipment keyless entry system.

ALARM/SIREN

POSITION

Install the compact alarms and the sirens on the wheelhouse, passenger’s side.

CENTRAL UNIT POSITION

Position the modular sistems and the modules under the dashboard, passenger’s side.

POWER SUPPLY

+30: connect to the 3 mm 2 RED wire in a multiway connector, passenger’s side.

-31: connect to the ground terminal located behind the driver’s side bulkhead.

IGNITION WIRE

+15/54: connect to the VIOLET/WHITE wire, in the wiring harness coming out of the black

tripolar connector near the fuse box. As alternative: connect in the wiring harness coming out

of the connector of the ignition key.

DIRECTION INDICATORS

Connection with separated lines

Connect to the BLUE/GREEN wire at the position nr.50, BLUE/YELLOW wire at the position

nr.18, BLUE/GREEN wire at the position nr.1, BLUE/BROWN wire at the position nr.11,

BLUE/YELLOW wire at the position nr.3 and BLUE/BROW wire at the position nr.43, in the 54

way black connector coming out of the position and low beam lights control switch.

Note: Separate the lines with 1N4004 diodes.

ELECTRIC WINDOWS

Negative control signal

The windows locking is obtained using the original radio control push-button of the vehicle.

ACTIVAT./DEACTIVATION

Connections antitheft/vehicle

CONTROLS

Position

Central connector, grey central

Car body

The grey central is located behind the glove compartment, passenger’s side.

Vehicle

WHITE

LIGHT BLUE

Ground

IMMOBILISATION POINT

Fuel pump

Cut the 1,5 mm 2 BROWN/YELLOW wire in the wiring harness coming out of the brown relay

located in the fuse box, in the black box, in the driver’s side engine compartment.

STARTER

+50: Cut the 3 mm 2 BLUE/BLACK wire in the wiring harness coming out of the connector of

the ignition key.

BONNET SWITCH

Install an additional switch on the headlamp support plate, near the original bonnet bumper

rubber.

DOORS SWITCH

Connect to the BROWN/BLUE wire coming out of the lamp in the passenger’s side. The signal

is with positive polarity.

BOOT SWITCH

Connect to the wire that activates the boot lamp, directly inside the boot.

HORN CONTROL

Positive control

Connect to the VIOLET/BLUE wire in the wiring harness coming out of the connector in

vertical position located in the frontal part of the fuse box.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

bmz403gbbt.doc

Art. 3800

GREY/BLACK

YELLOW/BLACK

VIOLET/WHITE

VIOLET

ORANGE

ORANGE/WHITE

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: