FOMON02GBBT.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

FORD

MOD. MONDEO*

YEAR. 02 ﬁ

PETROL

DIESEL

MAKE

* Models with original equipment keyless entry system.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens on the support of the servobrake, in the engine

compartment.

CENTRAL UNIT POSITION

The modular systems and the modules should be positioned behind the fuse box, under the

dashboard, driver’s side.

POWER SUPPLY

+ 30: Connect to the ORANGE/WHITE wire located in the wiring harness coming out of the

blue connector of the central locking unit placed behind the passenger’s side glove

compartment.

- 31: Connect to the BLACK wire located in the wiring harness coming out of the gray

connector of the central locking unit, placed behind the passenger’s side glove compartment.

IGNITION WIRE

+ 15/54: Connect to the 2 mm 2 GREEN/RED wire located in the wiring harness coming out of

the 2 way grey connector, in the fuse box.

DIRECTION INDICATORS

Connect to the BLUE wire in the wiring harness coming out of the grey connector and to the

BLUE/RED wire coming out of the green connector. The connectors are located on the central

locking unit placed behind the passenger's side glove compartment.

ELECTRIC WINDOWS

Comfort locking

To make the windows locking it is necessary to keep pressed the button of the original

radiocontrol.

ACTIVAT./DEACTIVATION

CONTROLS

Connections antithefts/vehicle

38XX vehicle Position

YELLOW/BLACK YELLOWBLACK (motor) Pos. nr.3 green connector

GREY/BLACK WHITE/BLACK (motor Pos. nr.5 green connector

VIOLET ORANGE/BLACK (lock) Pos. nr.19 grey connector

ORANGE GREEN/BLACK (unlock) Pos. nr.16 green connector

VIOLET/WHITE ground car body

ORANGE/WHITE positive (+30) power supply in the fuse box

The grey and green connectors are located on the coming out of the central doors locking unit

placed behind the glove compartment, passenger’s side.

Note: During the programming it is necessary to make both the lock and the double

locking of the doors (pressing 2 times uninterruptedly the button of the original

radiocontrol).

IMMOBILISATION POINT

Inertial switch

Cut the GREEN/ORANGE wire located in the wiring harness coming out of the connector of

the inertial switch placed behind the driver’s side lateral bulkhead.

STARTER

+ 50: Cut the GREY/WHITE wire located in the wiring harness coming out of the 14 way green

connector, on the connector’s holder plate, under the driver’s side dashboard.

BONNET SWITCH

Install an additional switch on the front headlamp support plate, driver’s side.

DOORS SWITCH

Connect to the RED/BLACK wire (front left) at the position nr.22 and to the GREEN/BLACK

wire (front right) at the position nr.21, on the coming out of the white connector; to the

BLACK/ORANGE wire (rear right) at the position nr.18, in the grey connector and to the

ORANGE/BLACK wire (rear left) at the position nr.15, in the green connector.

The connectors are located on the coming out of the central locking unit placed behind the

passenger’s side glove compartment. It is suggested to separate the lines with 4 diodes.

BOOT SWITCH

Connect to the wire coming out from the boot lamp. It is necessary to install a diode.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

fomon02gbbt.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: