FIMAR02GBBT.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

FIAT

MOD. MAREA* YEAR 02 ﬁ

PETROL

DIESEL

MAKE

* Models with original equipment keyless entry system.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens in the engine compartment, behind the headlamp on

the driver’s side, near the battery.

CENTRAL UNIT

Position the modular systems and the modules under the left side of the dashboard, driver’s side.

POWER SUPPLY

+ 30: connect to the 4 mm 2 RED wire located in the 2 way white connector in the fuse box.

- 31: connect to the general supply wiring located behind the left lateral bulkhead, drivers side.

IGNITION WIRE

+ 15/54: connect to the 1,5 mm 2 ORANGE wire located in the wiring harness and coming out of

the ignition key, alternatively to the 1mm 2 BLUE/RED wire located in the multiway connector in

the fuse box.

DIRECTION INDICATORS

Connect to the LIGHT BLUE wire in the 12 way white connector in the lower part, on the right, of

the fuse box, and to the LIGHT BLUE/WHITE wire in the 14 way white connector, on the right of

the fuse box.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the VIOLET/YELLOW wire at the position nr. 8, in the 20 way white connector, of the ABI

central located behind the glove compartment, passenger’s side.

Front window, passenger’s side:

cut the VIOLET/WHITE wire at the position nr. 9, in the 20 way white connector of the ABI

central located behind the glove compartment, passenger’s side.

ACTIVAT./DEACTIVATION

CONTROLS

Connections antitheft/vehicle

Art.3800 Vehicle Position

GREY/BLACK free position Pin nr.1, 8 way connector

YELLOW/BLACK +30 in the fuse box

VIOLET +30 in the fuse box

ORANGE +30 in the fuse box

ORANGE/WHITE +30 in the fuse box

VIOLET/WHITE +30 in the fuse box

The 8 way connector of the radio set is located in the original front roof lamp.

IMMOBILISATION POINT

Fuel pump

Cut the1,5 mm 2 BROWN/WHITE wire located in the white connector of the right lower part of the

fuse box.

STARTER

+50: Cut the YELLOW/BLACK wire located in the wiring harness coming out of the connector of

the ignition key.

BONNET SWITCH

Install an additional switch on the front headlamp support plate, near the rubber grommet of the

boot.

DOORS SWITCH

Connect to the BROWN/BLACK wire at the position nr. 2 (ant. left) and to the BROWN/GREY

wire at the position nr. 3 (ant. right) located in the wiring harness coming out of the 18 way

connector, on the coming out of the ABI central, behind the glove compartment, passenger’s

side.

BOOT SWITCH

Connect to the the 1mm 2 BLACK/VIOLET wire of the original push-bottons line or, to the wire at

the position nr. 14, on the coming out of the 20 way white connector, in the upper part of the fuse

box.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

fimar02gbbt.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: