u336s_v3_UsersGuide.pdf

U-336S and U-336SA

User’s Manual

Version 3.0

ZyXEL

T OTAL I NTERNET A CCESS S OLUTION

ZyXEL Limited Warranty

ZyXEL warrants to the original end user (purchaser) that this product is

free from any defects in materials or workmanship for a period of up to

two (2) years from the date of purchase. During the warranty period,

and upon proof of purchase, should the product have indications of

failure due to faulty workmanship and/or materials, ZyXEL will, at its

discretion, repair or replace the defective products or components

without charge for either parts or labor, and to whatever extent it shall

deem necessary to restore the product or components to proper

operating condition. Any replacement will consist of a new or re-

manufactured functionally equivalent product of equal value, and will be

solely at the discretion of ZyXEL. This warranty shall not apply if the

product is modified, misused, tampered with, damaged by an act of

God, or subjected to abnormal working conditions.

Note: Repair or replacement, as provided under this warranty, is the

exclusive remedy of the purchaser. This warranty is in lieu of all other

warranties, express or implied, including any implied warranty of

merchantability or fitness for a particular use or purpose. ZyXEL shall in

no event be held liable for indirect or consequential damages of any

kind or character to the purchaser.

To obtain the services of this warranty, please contact ZyXEL’s Service

Center, refer to the separate Warranty Card for your Return Material

Authorization number (RMA). Products must be returned Postage

Prepaid. It is recommended that the unit be insured when shipped. Any

returned products without proof of purchase or those with an out-dated

warranty will be repaired or replaced (at the discretion of ZyXEL) and

the customer will be billed for parts and labor. All repaired or replaced

products will be shipped by ZyXEL to the corresponding return

address, Postage Paid (USA and territories only). If the customer

desires some other return destination beyond the U.S. borders, the

customer shall bear the cost of the return shipment. This warranty gives

you specific legal rights, and you may also have other rights which vary

from state to state.

The contents of this book may not be reproduced (in any part or as a

whole) or transmitted in any form or by any means without the written

permission of the publisher.

Note: ZyXEL does not assume any liability arising out of the

application or use of any products, or software described herein.

Neither does it convey any license under its patent rights nor the patents

rights of others. ZyXEL further reserves the right to make changes in

any products described herein without notice. This document is subject

to change without notice.

Acknowledgments

Trademarks mentioned in this manual are used for informational

purposes only.

Trademarks are properties of their respective owners.

FCC Part 15 Information

This device complies with Part 15 of FCC rules. Operation is subject to

the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including

interference that may cause undesired operations.

This equipment has been tested and found to comply with the limits for

a CLASS A digital device pursuant to Part 15 of the FCC Rules. These

iii

limits are designed to provide reasonable protection against harmful

interference in a commercial environment. This equipment generates,

uses, and can radiate radio frequency energy, and if not installed and

used in accordance with the instructions, may cause harmful interference

to radio communications.

If this equipment does cause harmful interference to radio/television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or

more of the following measures:

•

Reorient or relocate the receiving antenna.

•

Increase the separation between the equipment and the receiver.

•

Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

•

Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party

responsible for compliance could void the user’s authority to operate

the equipment. Shielded RS-232 cables are required to be used to

ensure compliance with FCC Part 15, and it is the responsibility of the

user to provide and use shielded RS-232 cables.

Information for Canadian Users

The Industry Canada label identifies certified equipment. This

certification means that the equipment meets certain telecommunications

network protective, operation, and safety requirements. The Industry

Canada does not guarantee that the equipment will operate to a user’s

satisfaction.

Before installing this equipment, users should ensure that it is permissible

to be connected to the facilities of the local telecommunications

company. The equipment must also be installed using an acceptable

method of connection. In some cases, the company’s inside wiring

associated with a single line individual service may be extended by

means of a certified connector assembly. The customer should be

aware that the compliance with the above conditions may not prevent

degradation of service in some situations.

Repairs to certified equipment should be made by an authorized

Canadian maintenance facility designated by the supplier. Any repairs or

alterations made by the user to this equipment, or equipment

malfunctions, may give the telecommunications company cause to

request the user to disconnect the equipment.

For their own protection, users should ensure that the electrical ground

connections of the power utility, telephone lines, and internal metallic

water pipe system, if present, are connected together. This precaution

may be particularly important in rural areas.

Caution: Users should not attempt to make such connections

themselves, but should contact the appropriate electrical

inspection authority, or electrician, as appropriate.

This digital apparatus does not exceed the class A limits for radio noise

emissions from digital apparatus set out in the radio interference

regulations of Industry Canada.

The declarations of CE marking:

Note: This applies only for U-336S model.

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: