S2Ctiled.PDF

Notes on the fuse:

If you are going for all out light weight, consider leaving out

the fuse spar. The side plates are strong enough for anything

in flight, but will not be quite as tough for rough

landings/crashes. Make sure to use 15-30 minute epoxy or

shoogoo for the main parts...5 min and foam CA are not

strongenough, and will crack under the torque.

1° possitive incidenc

3/8"x3/8" Hardwood motor block

Groove block to fit carbon rod.

If using GWS 350 Drive, mount

block on Carbon rod so that the

prop/drive shaft is in the same

location as shown on plans.

ce on top wing only

1/8" Lite ply center strut

Connect upper and lower

ailerons with 1/16 carbon

or steel pushrod

All hinging for control surfaces can be

tape or actual hinges. I prefer robar

points epoxied in place for the added

and control freeness.

Elevator Servo (HS-56HB Sho

e packing

rt hinge

longivity

own)