watering_can_pin.pdf

(14 KB) Pobierz
PROJECT watering can pin
W ATERING C AN PIN
DESIGNED BY MARY COSGROVE
Materials needed:
• QuickCount® 10-ct plastic canvas by Uniek
• Kreinik Heavy (#32) Braid 025 Gray, 091 Star Yellow
• Kreinik 1/8” Ribbon 012HL Purple Hi Lustre
• DMC embroidery floss in 415 Very Light Pewter, 208 Very Dark Lavender,
702 Kelly Green, 3804 Dark Cyclamen Pink
• Fabri-Tac™ Permanent Adhesive by Beacon™
• Scissors
• Plastic canvas needle (No. 18)
• Backing material: fabric, perforated paper, card stock, etc
• Pinback
BASE:
18 X 18
HOLES
BACKGROUND:
16 X 16 HOLES
Instructions:
1. Cut canvas according to graphs, and as follows:
BASE 18 x 18 holes
BACKGROUND 16 x 16 holes
WATERING CAN 12 x 11 holes, cut out shaded area on handle
FLOWERS cut 2, 5 x 5 holes
fill in completely
with continental
stitches
CUT OUT
2. Using #32 Braid 091 Star Yellow, work the background piece completely in
continental stitches. Overcast the edges with Star Yellow.
3. Using six strands of DMC 415 Very Light Pewter, work the watering can in
continental stitches. Add #32 Braid 025 Gray continental stitches as indicated.
Overcast the outside and cut-out edges of the watering can with #32 Braid 025
Gray.
4. Overcast the petals of one flower in six strands of DMC 208 Very Dark
Lavender, the other in 3804 Dark Cyclamen Pink.
WATERING CAN:
12 X 11 HOLES
5. Holding background piece like a diamond, tack the bottom of the watering
can to background, 1/2” from the bottom corner with #32 Braid 025 Gray. Tack
the handle and spout, but leave the top open.
FLOWERS:
CUT TWO,
5 X 5 HOLES
6. Place the flowers slightly inside the top of the watering can, and tack the
center of the flowers to the background using six strands of DMC 208 Very
Dark Lavender on the pink flower and 3804 Dark Cyclamen Pink on the laven-
der flower.
7. Using #32 Braid 091 Star Yellow, whipstitch background to unstitched
base, leaving one hole around all edges.
8. Overcast edges of base with six strands of DMC 702 Kelly Green.
Color Key:
208 Vy Dk Lavender
3804 Dk Cyclamen Pink
415 Vy Lt Pewter
9. Cut a 9-inch piece of 1/8” Ribbon 012HL Purple Hi Lustre. Glue with
Fabri-Tac™ to the background, below watering can, tacking at intervals while
twirling/winding ribbon to make loops. Glue backing material to back of pin.
Glue pinback to center of backing material.
025 Gray #32 Braid
© Copyright 2003 Kreinik. This chart may be reproduced but not sold.
Kreinik Consumer Info: 1-800-537-2166 or www.kreinik.com.
213796611.001.png 213796611.002.png 213796611.003.png 213796611.004.png
 

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika:

Zgłoś jeśli naruszono regulamin