MEML303GBB.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

MAKE MERCEDES MOD.

ML 320

YEAR 03 ﬁ

PETROL

DIESEL

ALARM/SIREN

POSITION

Position the compact alarms and the sirens in the engine compartment, on the bracket near

the driver’s side headlamp.

CENTRAL UNIT POSITION

Position the modular sistems and the modules under the dashboard, driver’s side.

POWER SUPPLY

+30: connect to the 13 mm 2 pin with RED cables located in the tinned box in the driver’s side

engine compartment.

-31: connect to the 8 mm 2 pin with BROWN cables located in the tinned box in the driver’s

side engine compartment.

IGNITION WIRE

+15/54: connect to the 10 mm 2 pin located in the tinned box in the driver’s side engine

compartment.

DIRECTION INDICATORS

Connect to the PINK wire at the position marked E13 and to the GREEN wire at the position

marked E5, located in the 14 way red connector, at the position marked C/E in the tinned box,

in the driver’s side engine compartment.

CENTRAL DOORS LOCKING Negative control signal

Connect with both the wires of opening and locking of the antitheft to the PINK wire marked

nr.3371 at the position B8 ( in some versions the position is B2), located in the wiring harness

coming out of the 24 way grey connector marked 3, of the central unit placed behind the fuse

box, in the driver’s side engine compartment.

Note: insert a 180 Ohm resistance in serie to the ORANGE wire of the antitheft.

IMMOBILISATION POINT

Injection immobilisation central unit (starting)

Version with fuse box with numeric indications

Cut the wire coming out of the position nr.36 of the connector nr.4 coming out of the injection

central unit, in the tinned box in the driver’s side engine compartment.

Version with fuse box with nonnumeric indications

Cut the 0,5 mm 2 BLUE wire at the position nr.29 of the connector marked C, coming out of the

injection central unit, in the tinned box in the driver’s side engine compartment.

BONNET SWITCH

Install an additional switch on the headlamp support plated, near the original rubber bumper

bonnet.

DOORS SWITCH

Connect to the 1mm 2 GREEN wire in the wiring harness coming out of the connector of the

lamp under the driver’s side dashboard.

BOOT SWITCH

Connect to the 1mm 2 WHITE wire in the wiring harness coming out of the connector marked

P/D, in the fuse box.

POSITION GSM-GPS

ANTENNAS

GSM antenna

Position the GSM antenna in the upper part of the front window, in correspondence of the

darkened zone on the side of the rear view mirror.

GPS antenna

Position the GPS antenna in the upper part of the odometer, under the driver’s side

dashboard.

HORN CONTROL

Positive control

Connect to the 1 mm 2 ORANGE wire, at the position nr.8, in the blue connector marked

ML/A, in the tinned box in the driver’s side engine compartment.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

meml303gbb.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: