HYSAN02GBB.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

HYUNDAI

MOD. SANTA FE’ YEAR 02 ﬁ

PETROL

DIESEL

MAKE

ALARM/SIREN

POSITION

Position the compact alarms and the sirens on the driver’s side wheelhouse.

CENTRAL UNIT POSITION

Position the modular systems and the modules under the dashboard, driver’s side.

POWER SUPPLY

+30: connect to the 4 mm 2 RED wire in the multiway connector, in the fuse box.

-31: connect to one of the ground terminals behind the left lateral bulkhead, driver’s side.

IGNITION WIRE

+ 15/54: connect to the BLUE/ORANGE wire, at the position nr.7, of the 15 way white

connector placed above on the right of the fuse box, under the driver’s side dashboard.

DIRECTION INDICATORS

Connect to the GREY wire, at the position nr. 1 and to the LIGHT GREY wire, at the

position nr. 2, in the wiring harness coming out of the 15 way white connector placed

above, on the right, in the fuse box, under the driver’s side dashboard.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the BROWN wire located in the wiring harness coming out of the driver’s side push

button.

Front window, passenger’s side:

cut the GREY wire.

Rear window, driver’s side:

cut the YELLOW wire.

Rear window, passenger’s side:

cut the PINK wire.

The above connections are made in the wiring harness coming out of the driver’s side door.

CENTRAL DOORS LOCKING

Negative control signal

Connect to the YELLOW wire (lock) and to the YELLOW/ORANGE wire (unlock) located in

the wiring harness coming out of the 22 way white connector behind the left lateral

bulkhead, driver’s side.

IMMOBILISATION POINT

Fuel pump

Cut the RED wire located in the wiring harness coming out of the 20 way white connector

placed behind the relais holder box, on the right, near the battery, in the engine

compartment.

STARTER

+50: Cut the BLUE wire located in the wiring harness coming out of the connector of the

ignition key.

BONNET SWITCH

Install an additional switch on the headlamp support plate, driver’s side.

DOORS SWITCH

Connect to the 1 mm 2 YELLOW wire, in the wiring harness coming out of the 8 way white

connector, under the connector concerning the connection of the direction indicators.

BOOT SWITCH Connect to the 0,5 mm 2 BLACK/BROWN wire located in the wiring harness that from the

driver’s side front sill cover goes towards the rear part of the vehicle.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

hysan02gbb.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: